logo fulling motor
hybrid stepper

HYBRID STEPPER

Stepper motors are motion systems allowing to have a high positioning precision.With their high power already at low speed, their stall torque and the possibility to divide the steps in microsteps, stepper motors can provide direct and precise motions in a small volume.Permanent magnet and hybrid technologies are used to provide a full range of solutions.The absence of mechanical commutation gives to these motors a long life time which is usually given by the sleeves according to the load applied on the shaft.

brushless motor

BRUSHLESS MOTOR

A brushless DC motor (BLDC) is a synchronous electric motor which is powered by direct-current electricity (DC) and which has an electronically controlled commutation system, instead of a mechanical commutation system based on brushes. In such motors, current and torque, voltage and rpm are linearly related.

pm_stepping_motor

PM STEPPING MOTOR

Often referred to as a “tin can” or“ can stack” motor the permanent magnet step motor is a low cost and low resolution type motor with typical step angles of 7.5 to 15° (48 – 24steps/revolution) PM motors as the name implies have permanent magnets added to the motor structure. The rotor no longer has teeth as with the VR motor. Instead the rotor is magnetized with alternating north and south poles situated in a straight line parallel to the rotor shaft. These magnetized rotor poles provide an increased magnetic flux intensity and because of this the PM motor exhibits improved torque characteristics when compared with the VR type.

ac servo motor

AC SERVO MOTOR

A Servo Motor is defined as an automatic device that uses an error-correction routine to correct its motion. The term servo can be applied to systems other than a Servo Motor; systems that use a feedback mechanism such as an encoder or other feedback device to control the motion parameters. Typically when the term servo is used it applies to a 'Servo Motor' but is also used as a general control term, meaning that a feedback loop is used to position an item.

special solutions

special solutions

Fulling Motor can develop all kinds of stepping motor, DC motor, AC motor, DC brushless driver, Mechanical Component to match customer demands. Our strong R/D team will be available for any special request. If you don't find what you are looking for in our catalog don't esitate to conatct us See here some of our Special Solutions.

  • testata
  • testata
  • testata

NEW FLAT BRUSHLESS 45BLW18

NEW FLAT BRUSHLESS 45BLW18

BLDC flat motors are the ideal solution for many applications due to their compact, flat design (45mm diameter; length <30 mm). In the new 45BLW motors (16 pol[...]

continue . . .

NEW 57BLSH BRUSHLESS MOTOR

NEW 57BLSH BRUSHLESS MOTOR

Fulling Motor is launching two new brushless, three-phase motors onto the market: 57BLSH40 and 57BLSH60.These two products are increasing the already wide rang[...]

continue . . .

FULLING MOTOR VIDEO

FULLING MOTOR VIDEO

Have a look to our New Video[...]

continue . . .

NEW FACTORY OPENING

NEW FACTORY OPENING

Dear Customer,The new plant of Fulling Motor has been completed. The detailed address is #69 Kunlun Road, located inthe north of old factory, just 3 minutes&rsq[...]

continue . . .